Ryobi BD4601 Manuel de l'opérateur télécharger pdf (Page 10)

10 - English

OPERATION

WARNING:

Applying the workpiece to the right side of the sanding

disc could cause the workpiece to kickback and/or loss

of control. Failure to heed this warning could result in

serious personal injury.

WARNING:

Do not reach across the sanding disc to turn the belt/

disc sander ON or OFF. Contact with the sanding disc

can result in serious personal injury.

POWER SWITCH

See Figure 11, page 16.

The belt/disc sander is equipped with a power switch that

has a built-in locking feature. This feature is intended to

prevent unauthorized and possible hazardous use by chil-

dren and others.

TO TURN THE BELT/DISC SANDER ON:

 With the switch key inserted into the switch, lift the switch

button to turn ON.

TO TURN THE BELT/DISC SANDER OFF:

 Press the switch button down to turn OFF.

WARNING:

ALWAYS remove the switch key when the tool is not in

use and keep it in a safe place. In the event of a power

failure, turn the switch OFF and remove the key. This ac-

tion will prevent the tool from accidentally starting when

power returns.

WARNING:

ALWAYS make sure your workpiece is not in contact

with the belt before operating the switch to start the tool.

Failure to heed this warning may cause the workpiece to

be kicked back toward the operator and result in serious

personal injury.

WARNING:

To reduce the risk of accidental starting, ALWAYS make

sure the switch is in the OFF position before plugging

tool into the power source.

LOCKING THE SWITCH

See Figure 12, page 16.

 Place the switch in the OFF position.

 Wait until the belt/disc sander has come to a full and

complete stop.

 Remove the switch key from the switch assembly. Store

key in safe place.

BEVEL SANDING

See Figures 13 - 14, page 16.

The worktable can be tilted from 0° to 45° for bevel sand-

ing. For angles 30º and above, position sander to the edge

of the work bench and mount sander in place as shown in

figures 9 and 10.

To tilt the worktable:



Loosen the table lock knob by turning it counterclockwise.

 Set worktable to desired angle.

 Tighten the table lock knob by turning it clockwise.

SANDING SMALL END SURFACES USING THE

MITER GAUGE

See Figure 15, page 16.

A miter gauge is included with the tool for increased

accuracy. Use of a miter gauge is recommended for sanding

small end surfaces on the sanding disc.

NOTE: Always move the workpiece across the sanding disc

from the left side toward the center.

HORIZONTAL AND VERTICAL SANDING

See Figure 16, page 17.

The belt/disc sander can sand both vertically and horizon-

tally. Depending on the workpiece, use the work support

for horizontal sanding operations and use the work table for

vertical sanding operations.

 Using the hex key provided, loosen the positioning bolt

by turning the bolt counterclockwise.

 Move the sanding belt into a vertical position.

 Lock the sanding belt by retightening the positioning bolt.

NOTE: Sand long workpieces with the sanding belt in the

vertical position by moving the work evenly across the

sanding belt.

WARNING:

ALWAYS use the work support for horizontal sanding and

use the work table for vertical sanding. Using the sander

without also using the work support or work table may

expose the operator to pinch points and could result in

serious personal injury.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi BD4601 Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BD4601